Why a water fine filter can result in problems
The system:
Water that is used for washing high-purity products.
Failure:
Too many particles percent in the water
Possible solution:
Add a filter. The manager requested to add 10 nm filter to be in the sequence to the 100nm filter. It is expected that the proposed change will improve a particle performance
Real problem:
To define what is the real risk, create a model of the failure and generate a mitigation/failure prevention
Water | 10 |
Filter 100nm | 6 2.5 |
H2O agglomerates | 6 10 |
H2O Molecules | 6 8.8 |
Particles | 4 |
Filter 10nm | 2 10 |
Fittings and all the parts of the system | 2 3.3 |
Pump | 2 |
Molecules of water create agglomerates having a size of tens mn. The number of free H2O molecules defines the water activity. The fine filter destroys the agglomerates and increases the number of free molecules H2O that increases the water activity - high interaction rate, high evaporation rate, etc. The elevated activity of the water may result in the dissolution and precipitation of new defects and particles. To ensure successful performance 40 Inventive principles should be enrolled to find a solution to the problem
If | If I use a very fine filter |
|---|---|
Then | The purity of the water will be improved - the water will be pure from particles |
But | The agglomerates of the water will be destroyed and the activity on the water will be increased |
Similar projects
The process is related to microelectronics - microchip manufacturing. The purpose of the process is to create a SiO2 layer on the surface of a Si wafer. Equipment: Vertical furnace to heat the wafers in the Q2 atmosphere and perform oxidation on the wafer surface. Process: The oxidation occurs on the front side and on the back side of the wafer Requirements: Create a SiO2 thin layer with a certain thickness and low sigma - low standard deviation of the thickness between the wafers and within the wafer Failure: Wafers from the lower zone have higher thickness and significantly higher within wafer sigma (standard deviation of the thickness within the wafer)
Wet cleaning is widely used in microchip manufacturing. Single wafer equipment is working as follows. A wafer rotates, and chemistry is poured from a movable nozzle. Water rinsing is performed at the end of the process. Loading of a new batch of the chemistry resulted in excursion - a strongly increased amount of defects was observed on the wafer after the processing. The project is dedicated to the failure analysis and creation of innovative solutions.
Flash heating of a wafer is widely used in microchip manufacturing. The purpose of the process is to prevent the diffusion of ions and atoms. During the flash process, a wafer breakage occurs. The project's purpose is to learn and understand the mechanism of the wafer breakage and propose the solutions to prevent the wafer breakage