Increase the removal rate of Cu at CMP

This project applies Functional Modeling to analyze the single-wafer wet etch process in semiconductor manufacturing. The model shows that wet etch defects are not caused only by chemistry, but also by interactions between the wafer, liquid flow, air, rotation, rinsing, drying, drain, and chamber environment. Key challenges include incomplete wetting, trapped air or bubbles, residue and particle redeposition, evaporation-driven watermarks, and contamination during rinse or drying. The project identifies improvement directions such as better wafer pre-wetting, controlled airflow, reduced evaporation, optimized rinse and drying conditions, and alternative chamber concepts such as face-down processing in a shallow liquid bath.

Wet cleaning is widely used in microchip manufacturing. Single wafer equipment is working as follows. A wafer rotates, and chemistry is poured from a movable nozzle. Water rinsing is performed at the end of the process. Loading of a new batch of the chemistry resulted in excursion - a strongly increased amount of defects was observed on the wafer after the processing. The project is dedicated to the failure analysis and creation of innovative solutions.

Flash heating of a wafer is widely used in microchip manufacturing. The purpose of the process is to prevent the diffusion of ions and atoms. During the flash process, a wafer breakage occurs. The project's purpose is to learn and understand the mechanism of the wafer breakage and propose the solutions to prevent the wafer breakage